Load the module using either the insmod or modprobe command: Might not be correct for certain Linux distributions.ĥ. The install locations listed above are the default locations. ForĮxample, use /home/username/e1000e or /usr/local/src/e1000e. Move the base driver tar file to the directory of your choice. RPM functionality has only been tested in Red Hat distributions.ġ. If you have just recompiled the kernel reboot the system now. Match the version and configuration of the installed kernel sources. NOTE: For the build to work properly, the currently running kernel MUST To build a binary RPM* package of this driver, run 'rpmbuild -tb Modify /etc/nf to point your PCIe devices to use the new e1000eĭriver using alias ethX e1000e, or use your distribution's specific methodįor configuring network adapters like RedHat's setup/system-config-network Install the e1000e driver using the instructions in the Building and Using the instructions in the e1000 README.
If your version of e1000 is 7.6.15.5 or less, upgrade to e1000 version 8.x, If you currently have the e1000 driver installed and need to install e1000e, NOTE: The Intel(R) 82562v 10/100 Network Connection only provides 10/100įor more information on how to identify your adapter, go to the Adapter &įor the latest Intel network drivers for Linux, refer to the following Instructions on updating ethtool can be found in the section "Additional Or later), lspci, and ifconfig to obtain the same information. Alternatively, you can use ethtool (version 1.6 The driver information previously displayed in the /proc filesystem is not The following features are now available in supported kernels:Ĭhannel Bonding documentation can be found in the Linux kernel source: Requirements listed apply to use with Linux. For questions related to hardware requirements, refer to theĭocumentation supplied with your Intel Gigabit adapter. Not supplying patches against the kernel source to allow for static linking
This driver is only supported as a loadable module at this time. NOTE: The 82546GB part requires the e1000 driver, not the e1000e driver. Thisĭriver includes support for Itanium(R)2-based systems. This driver supports kernel versions 2.4.x, 2.6.x, and 3.x. This file describes the e1000e Linux* Base Driver for Intel Ethernet NetworkĬonnection. Linux* Base Driver for Intel(R) Ethernet Network Connection
0 kommentar(er)
